|
Post by philboy on Jan 25, 2015 18:22:23 GMT
Excuse my ignorance but I need to fit new bearings in my 2013 sb66c, you can see the switch link physically moving when you flex the frame/crank on workstand so they're goosed, to be honest should have replaced a while ago. I bought a cheap set from a guy on ebay advertised as SB66c bearing set but I'm thinking I might just be better to buy and install proper yeti jobs, are the ones advertised on yetifan shop for sb66 with carbon swing arm the ones I need?
|
|
|
Post by Andrew on Jan 25, 2015 19:14:16 GMT
|
|
|
Post by Andrew on Jan 25, 2015 19:15:20 GMT
|
|
|
Post by philboy on Jan 25, 2015 21:02:34 GMT
Thank you
|
|
|
Post by philboy on Jan 25, 2015 21:13:11 GMT
Crap, I just clicked on your 1st link Andrew and purchased and then I saw your second link, do you have anything to do with the online shop purchases?
|
|
|
Post by Andrew on Jan 25, 2015 21:14:39 GMT
Yes that's me, I'll refund you and you can re order the correct one.
|
|
|
Post by Andrew on Jan 25, 2015 21:15:36 GMT
No need to do special delivery on them, I send them as that anyway.
|
|
|
Post by philboy on Jan 25, 2015 21:17:43 GMT
Ok, thanks, I'll go an order the correct ones just now, the previous wrong ones were Order ID is: #3250
|
|
|
Post by Andrew on Jan 25, 2015 21:18:17 GMT
Just sorted. You should have an email right now
|
|
|
Post by philboy on Jan 25, 2015 21:21:14 GMT
That's them ordered again Andrew, Order ID is: #3251, thanks for your help
|
|
|
Post by Andrew on Jan 25, 2015 23:30:54 GMT
Done am at bike show tomorrow, so expect them weds I think. Unless I can get back in time. Thank you for your order. Appreciate it.
|
|
|
Post by philboy on Jan 26, 2015 18:24:50 GMT
Cheers, hoping to fit this weekend so all good
|
|
|
Post by Andrew on Jan 26, 2015 19:09:47 GMT
Check the bump stop condom - usually it's ruined. Let me know if it is. Allen key under the frame gets it out.
|
|
|
Post by philboy on Jan 27, 2015 17:45:58 GMT
OK Andrew, do you sell these, send me a link if you do
|
|
|
Post by philboy on Jan 27, 2015 17:50:05 GMT
Andrew, if the bump stop condom is something that usually wears and needs replaced when bearings do, without even looking I would think that I would need one as I've been running the bike for sometime knowing that the bearings needed changing to be honest.
|
|