romas
Call me Mr YETI
Posts: 52
|
Post by romas on Mar 18, 2008 12:47:10 GMT
Hi! Do you know how to take off the 4 upper bearing of the linkage on a Yeti ASR-SL. For the other one no problems, I've got the linkage tool! Perhaps I have to use it too? Many thanks Bye
|
|
|
Post by Andrew on Mar 18, 2008 13:33:28 GMT
that one is always very tight.
Undo bolt around 1 full turn,and tap. this will loosen the pin.
Then undo one more turn and tap again. This will further loosen the pin.
The pin sticks inside the bearings of the bogbone.
Andrew
|
|
romas
Call me Mr YETI
Posts: 52
|
Post by romas on Mar 18, 2008 14:58:42 GMT
I was talking about the bearing inside the linkage... ;D
Thanks
|
|
|
Post by Andrew on Mar 18, 2008 15:04:27 GMT
Sorry!
You need to press it out, I am unsure if the Yeti tool can do this? If not you can use a regular socket thats the right size.
Andrew
|
|
romas
Call me Mr YETI
Posts: 52
|
Post by romas on Mar 18, 2008 15:25:06 GMT
They all go out to the same side (right or left)?
Thanks
|
|
|
Post by Andrew on Mar 18, 2008 15:41:54 GMT
They can go out either side. All 4 can slide out.
When you put them back in, I would put 2X right and 2X left.
|
|
romas
Call me Mr YETI
Posts: 52
|
Post by romas on Mar 18, 2008 15:51:08 GMT
Yes of course! Thanks Bye
|
|
|
Post by Eddy B on Mar 18, 2008 19:35:39 GMT
The tool will take the bearings all the way out. and will put them back in again.
|
|